Oil pressure meter and tester transmission 17 el. Magnus

Charakterystyka:

MEASUREMENT MEASUREMENTS OF OIL STRENGTHENS AND BIEG AFFAIRS – 17 ELEMENTS

This professional diagnostic system is a comprehensive solution for precision oil pressure testing in combustion engines and automatic transmissions. Caps the measurement and wide range of adaptors make the set irreplaceable when verifying the efficiency of oil pumps, the cost of lubrication systems and the calibration of pressure sensors.

Technical parameters:

• Measuring ranges:

  • 0–100 PSI / 0–0.7 MPa (dedicated to engines)

  • 0–400 PSI / 0–2.75 MPa (dedicated to gearboxes)

• Manometer diameter: 90 mm (large, readable scale)

• Cable length: 185 cm (flexible, oil-resistant)

• Thread types: Metric (M8–M12), NPT, BSPT

• Number of elements: 17 pieces

Key advantages of the diagnostic set:

• Double precision: Two separate manometers allow for a more accurate reading depending on the system being tested – the lower range is ideal for engines, while the higher in hydraulics gearboxes.

• Wide compatibility: Thanks to 14 adapters, these workshop tools fit most passenger, commercial and heavy goods vehicles available on the market.

• Work convenience: A very long cable (1.85 m) allows safe removal of the manometer from the engine chamber directly into the cab or glass, allowing observation of indications during operation of the engine under load.

• Protection of manometers: The measuring clocks are embedded in rubber shields that protect them from accidental impacts and falls under difficult workshop conditions.

Application:

These. measuring instruments are necessary for:

• Measurement of lubrication pressure in petrol and diesel units.

• Working pressure testing in automatic hydraulic transmissions.

• Comparison of control indications on the dashboard with the actual mechanical state of the system.

Package content:

1. Manometer 0–100 PSI In the shield.

2. 0-400 PSI Manometer In the shield.

3. Flexible wire 1.85 m with a quick connection.

4. 14 Adapters and Reductions (including M8, M10, M12 and inch standards).

5. Solid casethat provides order in yours tool cabinet.